There are many things that can go wrong when you are driving your Jeep vehicle. Whether it’s fixing a flat tire, changing the oil or whatever. But one thing is for sure, Nevertheless you have an automatic or manual transmission, you need to know how to remove the jeep shift knob with absolutely no tools(Replace it with the weighted shift knob for good driving felling). Here’s how to do it.

How To Remove The Jeep Shift Knob?

Almost everyone who buys a car with a manual transmission wants to know how to remove the steering column shift knob. They buy the car because they want the performance and handling of a stick shift, but don’t want to deal with the hassle of learning how to operate one. But almost everyone who buys a car with an automatic transmission also wants to be able to use the stick shift.

And, since most automatic transmission cars have an accessible steering column, it seems logical that the two groups of people would be able to remove the column shift knob in the same way. However, this is not the case. Removing the jeep shift knob on an automatic transmission car requires special tools and the ability to work on a car with a mechanic. On the other hand, removing the shift knob on a stick-shift car is a piece of cake.

Even the most mechanically challenged among us can remove this jeep shift knob with just a simple screwdriver.

You don’t have to be a mechanic to remove your shift knob. In fact, you probably don’t even need to get close to a car to do it. All you need is a pair of pliers, a strong pair of wire cutters and about five minutes. Start by getting to work on the front of your Jeep. Park as close to your vehicle as you can, so you don’t have to move it. Take the parking brake off, but make sure it doesn’t set too hard; you should be able to back up a few feet without any problem.

Now, use the pliers to remove the four nuts that are holding the shift knob in place. You’ll need to use the cutters to cut the nylon thread that is holding the shift knob in place. Pull it straight out of the car and away from the vehicle, and then put it on your work surface. If you are working on a nice flat surface like a driveway or a parking lot, there is no need to put something under the shift knob; just set it down and walk away. When you come back, you’ll find that it has “snapped” into place. It’s that easy to remove your shift knob.

Now, the same technique will work for just about any other part of your car that has a nut and bolt.

Conclusion:

In conclusion, if you would like to remove your jeep shift knob without using any tools whatsoever, continue reading this instructable. First, you are going to need some help from a friend or family member. Next, you are going to need to remove the rubber washer that is located underneath the shift knob.

After that, you are going to need to use a paper clip or similar object to pry up the retaining tab located at the top of the hole that the shift knob is located in. Once you have the retaining tab pulled up, the shift knob will come out very easily. Put the shift knob aside for now. Next, remove the two screws that hold the shift lever boot in place. Now, remove the boot itself.

Read more : 1979 jeep cherokee chief story